02-25-2024 01:32 AM
So long story short just unsure on this
We have users that have an unmanaged switch in their office that has their DHCP Computer and a Static printer connected to it and that unmanaged switch connects to my 9200 catalyst
So my question what config would I do to get them both to work?
Originally I thought I would just set it as a trunk port with the native VLAN being the DHCP VLAN but then printer won't ping
I thought setting the port as a regular trunk port should allow the printer to ping but it doesn't as well what am I missing?
02-25-2024 01:40 AM
unmanaged switch does not understand tagging, so configure the connected port on Cat 9K switch as access is advice.
DHCP Computer and a Static printer - i take this both are in same subnet and belong to same VLAN ?
02-25-2024 02:21 AM
before connect unmanged SW to C9200 can you confirm that C9200 dont use vlan1 for any host ?
MHM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide