cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Popup Hotspot Using ISR 1000 with WiFi/LTE for Teleworkers and Micro Branchesr
726
Views
0
Helpful
1
Replies
Highlighted
Beginner

Steps to install license on RMA 4507+ SUP7LE

I have a RMA 4507+ SUP7LE that I need to reprovision the ipbase license for the replacement chassis.  I looked at the deployment guide for upgrade http://www.cisco.com/c/en/us/products/collateral/switches/catalyst-4500-series-switches/white_paper_c11-685524.html and have a few questions.

------------------------------------------------------------------------

After reading the license activation guide it has it as

 license install usb0:FOX1349GA3Z_20110108191907574.lic

license boot level ipbase

reload <making standby in slot 4 to active>

-console into previously active sup in slot 3 and issue break sequence to prevent it from booting to force into ROMMON mode

 -after the New active SUP engine stabilizes to allow the NEW standby to fully boot

-after the standby stabilizes SSO should be restored and both SUP engines have IPBASE license active in-use

-once confirmed make the SUP engine in slot 3 back into active

redundancy force-switchover

<confirm everything is normal and stable>

-----------------------------------------------------------------------

Instead of doing all of those steps can't I just do it this way:

license install usb0:FOX1349GA3Z_20110108191907574.lic

<check if sso is running if not enable it>

conf t
redundancy
mode sso

end

copy run start

power cycle the entire chassis

show license image level  <to confirm both active and standby SUP engines have ipbase installed

1 REPLY 1
Highlighted
Beginner

Bump^  Anyone?

Bump^  Anyone?

CreatePlease to create content
Content for Community-Ad