cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1580
Views
5
Helpful
3
Replies
Beginner

Storm-Control on X6704-10GE

Since storm-control on 10G interface was enabled, following message began logged in syslog.


>> %PM_PLATFORM-5-PORTDROP: Port TenGigabitEthernet1/1 dropped packets due  to storm control


There is no application using broadcast or multicast, so ifInBroadcastPkts and ifInMulticastPkts are very low.
And I found the message appeared only when input rate was above 50Mbps.
The suppression level was configured 0.50% at Te1/1.
I think there is a bug because 50Mbps is 0.50% of 10Gbps, but BugToolkit gave no answer.

The hardware is SUP720-3C + X6704-10GE, IOS is 12.2(33)SXH
This Cat also has X6748-SFP, and storm-control are working fine without false message on these I/F.

Any hints or suggestions are appreciated.
## port monitor will be a last way because the Cat6500 is already in customer site and they don't like we take thier data.

3 REPLIES 3
Highlighted
Rising star

Re: Storm-Control on X6704-10GE

This is the third time you have posted this discussion and deleted the others!!

Highlighted
Rising star

Re: Storm-Control on X6704-10GE

Is you IOS code 12-2(33)SXH4?

See this bug CSCta93296. Even though the bug says ACE, it does apply to other modules on the 6500 with that code..

Francisco.

Highlighted
Beginner

Re: Storm-Control on X6704-10GE

Yes, 12.2(33)SXH4.

Thanks a lot for your reply.

I will contact our vendor to get detailed information of CSCta93296.

And I appologize for my repeated post.

(I deleted last 2 post because the ID was not mine)

CreatePlease to create content
Content for Community-Ad