11-28-2011 09:46 PM - edited 03-07-2019 03:38 AM
Dear Friendz,
Connectivity: Telecom Equipment(TE)----RouterA----RouterB.
Pinging from RouA to TE worksbut trace route fails stating "% Subnet not in table".
IP address of TE in defined in OSPF table of RouterA.
Which all points to be checked? Please help...
Solved! Go to Solution.
11-28-2011 11:37 PM
Is the route in the routeing table?
Amd do you see the route when using this command:
show ip ospf database
11-28-2011 11:37 PM
Is the route in the routeing table?
Amd do you see the route when using this command:
show ip ospf database
11-28-2011 11:50 PM
Hi Sharone,
Is the neighborship established between TE and RouterA?
Can you make sure the TE network specified under OSPF?
Please rate the helpfull posts.
Regards,
Naidu.
11-29-2011 12:37 AM
Hi,
Pinging from RouA to TE worksbut trace route fails stating "% Subnet not in table".
How can a ping work if the subnet you are trying to reach is not in the routing table ?
Are you tracerouting to a remote subnet beyond TE ?
Regards.
Alain
11-29-2011 10:00 AM
Thank you friends,
Earlier i checked in the sh run and the IP was there under
router ospf 1
log-adjacency-changes
But in show ip ospf database the IP is not there..
@Alain: Ping worked.. because there is a default route there and it took another path, that i havnt mentioned earlier and sorry for confusing..
Thanks all for the help.
11-30-2011 03:12 AM
Problem not yet solved !
in show ip ospf database the IP is not there..
But IP Route is Created and re-distribution done,
router ospf 1
log-adjacency-changes
redistribute static subnets route-map RNC
Still its not working, please help...
11-30-2011 03:27 AM
Hi,
post your config along with sh ip ospf database and sh ip route.
Regards.
Alain
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide