We have two cisco switch N77-C7706 and N77-C7710 connected with each other through L2 trunk link.
We have enable some of errdisable recovery option on both switches but only N77-C7710 is showing it enable but its still showing disabled on N77-C7706
N77-C7706 is showing link-flap, udld, bpduguard disabled even though they are enable.
Is it because recover timer is different on both side ?
N77-C7710 60 Seconds VS N77-C7706 360 Seconds
------------------------------------------
N77-C7710# show run | i errdisable
errdisable recovery interval 60
errdisable recovery cause link-flap
errdisable recovery cause udld
errdisable recovery cause bpduguard
errdisable recovery cause security-violation
errdisable recovery cause failed-port-state
N77-C7710# show errdisable recovery
ErrDisable Reason Timer Status
----------------- ------------
link-flap enabled
udld enabled
bpduguard enabled
loopback disabled
storm-ctrl disabled
sec-violation enabled
psec-violation disabled
vpc-peerlink disabled
failed-port-state enabled
event-debug disabled
event-debug1 disabled
event-debug2 disabled
event-debug3 disabled
event-debug4 disabled
miscabling disabled
eloam-discvr-timeout disabled
eloam-dying-gasp disabled
Timer interval: 60
----------------------------------
N77-C7706# show run | i errdisable
errdisable recovery cause link-flap
errdisable recovery cause udld
errdisable recovery cause bpduguard
errdisable recovery cause failed-port-state
N77-C7706# show errdisable recovery
ErrDisable Reason Timer Status
----------------- ------------
link-flap disabled
udld disabled
bpduguard disabled
loopback disabled
storm-ctrl disabled
sec-violation disabled
psec-violation disabled
vpc-peerlink disabled
failed-port-state enabled
event-debug disabled
event-debug1 disabled
event-debug2 disabled
event-debug3 disabled
event-debug4 disabled
Timer interval: 300
