cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1258
Views
15
Helpful
5
Replies

Switch module Install for 2951

Patrick McHenry
Level 4
Level 4

Does anyone have a doc for installing the a PoE switch module for a 2951? I find alot about the 2951 PoE Power supply but nothing for the switch module.

Thanks, Pat.

5 Replies 5

amohaida
Level 1
Level 1

What is the switching module you are going to install ?

Ahmad.

SM-ES2-24-P=

Thanks, Ahmad.

amohaida
Level 1
Level 1

Hi Patrick,

I don't think that there is a specific document for this enhanced etherswitch module , basically it is like any other netowrk module and you can install it following the steps in this document:

http://www.cisco.com/en/US/docs/routers/access/interfaces/nm/hardware/installation/guide/InstNetM.html#wp1046612

more useful information can be found in the following two links:

  • Connecting Cisco Enhanced EtherSwitch Service Modules to the Network

http://www.cisco.com/en/US/docs/routers/access/interfaces/nm/hardware/installation/guide/eesm_hw.html#wp1143505

  • General Information about Enhanced etherswitches modules on 299 and 3900 routers:

http://www.cisco.com/en/US/prod/collateral/routers/ps10536/data_sheet_c78-553980_ps10537_Products_Data_Sheet.html

***** NOTE that OIR is NOT supported on 2900 Routers .  Please power down the router and remove the power  cord before inserting the module.  Otherwise, you'll risk  short-circuiting the "pins" at the back and cause components of the  module or the router to burn.

HTH,

Ahmad.

{Don't forget to rate helpful posts.}

Thanks for the docs.

Do you also have a doc for the configuring of a 4G module in the 2951.?

Thank you, Pat.

Hi Patrick,

Installing 4g card is the same as other interface cards:

http://www.cisco.com/en/US/docs/routers/access/interfaces/ic/hardware/installation/guide/inst_ic.html

Separate SIM installation instructions:

http://www.cisco.com/en/US/docs/routers/access/interfaces/ic/hardware/installation/guide/EHWIC-4G-LTEHW.html#wp1139200

As for configuring it, this is the guide:

http://www.cisco.com/en/US/docs/routers/access/interfaces/software/feature/guide/EHWIC-4G-LTESW.html

Kind Regards,
Ivan Shirshin

**Please grade this post if you find it useful.

Kind Regards,
Ivan