The mean of class type control command

[Tareq Emad Al Asfoor]

Hello, 

Kindly, during my search i found this command using in ISG configuration 

Router(config-control-policymap)# class type control always event session-start

So, What this mean ...

Also 

Device(config-traffic-classmap)# match access-group input 100

Device(config-traffic-classmap)# match access-group output 100

What we mean by (input) and ( output ) ?

Kind regards, 

Kind Regards, 

[Peter Paluch]

Hi Tariq,

This answer is not probably going to be very useful but still... The type control used in class-map and policy-map constructs is used on Intelligent Service Gateways (ISGs). It is a large feature set for devices that act as entry points into a network for subscribers. There is an entire Configuration Guide devoted to ISGs here:

http://www.cisco.com/c/en/us/td/docs/ios-xml/ios/isg/configuration/xe-3s/isg-xe-3s-book.html

Probably the most interesting part for the beginning is the Overview of ISG chapter.

Best regards,
Peter

[Tareq Emad Al Asfoor]

Thanks, I already read this but actually, I didn't got the mean of the commands above and he didn't explain them in this book..