Tareq Emad Al Asfoor
Beginner
Beginner
Member since ‎08-05-2010
‎11-02-2022

User Statistics

  • 204 Posts
  • 1 Solutions
  • 24 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
1 Accepted Solution
50 Replies
20 Replies
10 Replies
5 Replies

User Activity

Dears, I have Cisco IOS-XE and want to see the output for the command (show policy-map interface) using Yang model to check the traffic byte for each class inside the policy .. so I used the model (Cisco-IOS-XE-policy). Still, i can't find the output...
Hi  all, I have NCS5508, when i check the command below sh controllers npu resources encap location 0/0/CPU0sh controllers npu resources encap location 0/1/CPU0 I found the below urrent Hardware UsageName: encapName: bank_0Estimated Max Entries : 409...
Hi , i have installed IOS XRv9000, and enabled BNG inside it ..  How i can add the number of subscriber session in PRTG ..is there any OID or MIB supported by XRv9000 Kind Regards  
Hi all , I installed ASR XRv-9k on ESXIS 6.5 , It's working fine .. When i write the command below I found (Throughput gauge: 1000000 Kbps) .. So, how I can increase it to 10G since I'm using 10G NIC  RP/0/RP0/CPU0:VBNG-Test#sh license platform detai...
Hi all , I'm working on XRv9k which already installed on hypervisor ESXI 6.5 , When i tried to config QinQ it's not work and can ad only one Vlan as a second second-dot1q .. How i can add range of VLAN in the second-dot1qinterface GigabitEthernet0/0/...
Community Statistics
Member Since ‎08-05-2010 01:33 AM
Date Last Visited ‎11-02-2022 12:52 AM
Posts 204
Helpful Votes Given To