cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
530
Views
1
Helpful
2
Replies

Time Stamp not displaying over SSH connection in Packet Tracer?

Nermin
Level 1
Level 1

I set up a simple SSH connection to a switch in Packet Tracer. I configured the logging to have time stamp with ( service timestamp log datetime). When i am on the switch console i can see the time stamp. But when i connect to it from another device with SSH connection, the logging will not display time stamp in SSH terminal? Is this a bug in Packet Tracer or am i doing something wrong?

Thanks,
Nermin

1 Accepted Solution

Accepted Solutions

Hi @Nermin 

 When you are logged through a Console connection the logging is enabled by default but when you connect through a network connection the logging is not enable by default. You need to use the command "terminal monitor" in order to force the logging.

 

View solution in original post

2 Replies 2

Hi @Nermin 

 When you are logged through a Console connection the logging is enabled by default but when you connect through a network connection the logging is not enable by default. You need to use the command "terminal monitor" in order to force the logging.

 

Hi @Flavio Miranda,

Thanks for your replay. That worked. 

Review Cisco Networking for a $25 gift card