Hi
Want to mention that we have configured few sub-interfaces too.
border router#sh interface Ten 0/0/0
TenGigabitEthernet0/0/0 is up, line protocol is up
Hardware is SPA-1X10GE-L-V2, address is bc17.6579.e277 (bia bc17.6579.e277)
Description: *te0/0/0* - *to coreswitch,te3/3*
MTU 1500 bytes, BW 10000000 Kbit/sec, DLY 10 usec,
reliability 255/255, txload 20/255, rxload 20/255
Encapsulation 802.1Q Virtual LAN, Vlan ID 1., loopback not set
Keepalive not supported
Full Duplex, 10000Mbps, link type is force-up, media type is 10GBase-SR/SW
output flow-control is on, input flow-control is on
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Input queue: 0/375/1238/1719 (size/max/drops/flushes); Total output drops: 2673209411
Queueing strategy: Class-based queueing
Output queue: 0/40 (size/max)
30 second input rate 811050000 bits/sec, 197425 packets/sec
30 second output rate 808476000 bits/sec, 197267 packets/sec
5216106870671 packets input, 2735320776306911 bytes, 0 no buffer
Received 542360263 broadcasts (0 IP multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 1147197616 multicast, 0 pause input
5211621651445 packets output, 2726859315982820 bytes, 0 underruns
0 output errors, 0 collisions, 2 interface resets
0 unknown protocol drops
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 pause output
0 output buffer failures, 0 output buffers swapped out
