03-28-2011 03:04 PM - edited 03-06-2019 04:18 PM
Hi everyone,
i have a doubt in command transport preferred.
What is the function of this command.since the command Transport input and Transport output doing the same thing,then why the command Transport preferred is needed.
06-05-2018 02:40 AM
Hi Sathya,
If none of the protocol was configured for incoming and outgoing connections (Transport input and Transport output), Then it will use the protocol mentioned in transport preferred command.
Please find the below table for your reference.
Regards,
Selva
06-05-2018 05:21 AM
Hello Sathiyamoorth,
Transport preferred
Transport preferred command is used to specify which transport protocol is used on connections whereas the transport input and transport output commands are used to explicitly specify the protocols allowed on individual lines for both incoming and outgoing connections.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide