Hi all, I am doing a switch upgrade and trying to test my new switch stack on the network. When I hook up my new switch to our network, I am going from the Ten1/1/1 port with fiber, and connecting it to the fiber patch panel. Once the connection is made, my desire is that I can go back to my remote computer and connect ssh to it. I am running the following commands: int te1/1/1 switchport trunk native vlan 9 switchport mode trunk switchport nonegotiate switchport trunk allow vlan 2-99 channel-group 2 mode active no lights are coming up on my switch. Even after running the "show int trunk" command, nothing shows up which lets me know that it is now registering correctly for some reason. Any suggestions? Thanks and much appreciated!
Inviting all network professionals in operations! We'd like to understand what would be valuable for you in a mobile application. Your response will help Cisco improve a product feature that could benefit you. Thanks!
Click here to take the sur...
Cisco’s software-defined wide area network (SD-WAN) solution allows user to quickly and seamlessly establish an overlay fabric to connect an enterprise’s data centers, branch and campus locations, as well as colocation facilities in order to imp...
1. Log into CLI of DNAC:
ssh maglev@< DNAC appliance IP> -p 2222
2. Run this curl command to get token to get member id:
curl -X POST -u admin:<admin user password> -H -V https://<CLUSTER-IP>/api/system/v1/identitymgmt/token
Enterprise Switching Business Unit is glad to announce Beta release 16.12.2 for all Catalyst 9200/9300/9400/9500/9600 and Catalyst 3650/3850 Platforms. This release is made available to allow users to test, evaluate and share fee...
Purpose of the document
This document describes the general recommendations or best practices when designing and deploying the Cisco SD-Access technology. The document assumes that the reader has a general overview of Cisco's SD-Access for Distributed C...