Hi all, I am doing a switch upgrade and trying to test my new switch stack on the network. When I hook up my new switch to our network, I am going from the Ten1/1/1 port with fiber, and connecting it to the fiber patch panel. Once the connection is made, my desire is that I can go back to my remote computer and connect ssh to it. I am running the following commands: int te1/1/1 switchport trunk native vlan 9 switchport mode trunk switchport nonegotiate switchport trunk allow vlan 2-99 channel-group 2 mode active no lights are coming up on my switch. Even after running the "show int trunk" command, nothing shows up which lets me know that it is now registering correctly for some reason. Any suggestions? Thanks and much appreciated!
