09-27-2012 05:21 AM - edited 03-07-2019 09:08 AM
Hello,
I have a question: How can i add two data vlans on cisco 2960 on one interfase?
i have 3 mac adresses on one interfase: one PC, one ipphone and one XP virtual machine(VM).
PC and VM are in one data vlan and phone is in voice vlan. i need to place the VM in another data vlan is it possible?
if so could you give me a link or place information here.
Regards,
Vadim
Solved! Go to Solution.
09-27-2012 06:45 AM
Hi,
you'll have to make this interface a trunk port with your PC vlan as native vlan.
Regards.
Alain
Don't forget to rate helpful posts.
09-27-2012 07:32 AM
Don't forget that your VM software must support 802.1Q vlan tagging. You have to configure the correct vlan for your virtual machine.
According to your description your switch has already been configured as a trunk as your phone uses another vlan than your pc. In that case you might only have to configure your VM software to tag the network traffic of your XP VM with a 802.1Q tag.
09-27-2012 06:45 AM
Hi,
you'll have to make this interface a trunk port with your PC vlan as native vlan.
Regards.
Alain
Don't forget to rate helpful posts.
09-27-2012 07:32 AM
Don't forget that your VM software must support 802.1Q vlan tagging. You have to configure the correct vlan for your virtual machine.
According to your description your switch has already been configured as a trunk as your phone uses another vlan than your pc. In that case you might only have to configure your VM software to tag the network traffic of your XP VM with a 802.1Q tag.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide