Two router to one switch

[SSibu]

Dear Cisco Community,

hope this message finds you well.

I have one network scenario in my lab,

Router 1: 10.100.30.5/24, Router 2: 10.30.60.1/24

Cisco Switch with following VLAN's:

VLAN 2:192.168.2.1/24, VLAN 3:192.168.3.1/24

Computer and other peripherals are in VLAN 2.

how pc's and other peripherals can connect internet. And is it possible to use two routers at same time for backup plan. 

[balaji.bandi]

There are different ways to depends on the requirement.

1.Are you looking to split the load between ISP

2. active standby ( ISP1 active if that fais the traffic will move to ISP2)

best is always use both the links for financial justification rather just leaving alone idle.

by saying that suggestion, you need to split the load ISP1 and ISP2 , that is VLAN2 will go to ISP 1 and VLAN 3 go to ISP2

in case ISP1 down, VLAN2 and VLAN3 traffic go via ISP2 (bear in mind when this happends VLAN NAT reset have small reset in the connection path) - same way when you ISP2 down, Lan3 have same effect.

I am not able to find the test i have done this same setup at this stage, its in my archieve some where (i will post when i find it)

For now here is some example guides and lab people already done and blog the steps to achieve this.

https://www.routerfreak.com/how-to-configure-hsrp-on-a-cisco-router/

https://www.networkstraining.com/cisco-router-hsrp-configuration/

[SSibu]

Hello

Dear balaji can you give any example.

[balaji.bandi]

above examples are give you enough steps and exmaple config, you can develop on top of it based on the outcome.

[MHM Cisco World]

friend 
only make SW as L3 SW with ip routing command, then config defualt rout to router you want to access internet 
in router config static route toward SW for each VLAN in SW 
in router config NAT overload for access internet. 

for backup 
in SW config two defualt route one with high AD (backup)

that what you need.

[SSibu]

Dear

can you elaborate bit more. Really appreciated 

[MHM Cisco World]

[SSibu]

Dear MHM,

hope this message finds you well.

kindly advice on below scenario.

[SSibu]

Really appreciated your help and support.

[Martin L]

You can attach PT lab here but must be in a zip format 

Regards, ML
**Please Rate All Helpful Responses **

[SSibu]

Dear Martin L,

Kindly advice for below.

thanks in advance.

[Martin L]

not a picture but the actual file of PT, aka pkt file that u can save and re-open using PT. 

Regards, ML
**Please Rate All Helpful Responses **

[SSibu]

Dear Martin,

kindly find the attached zip fie.

thanks