UCS-E Interfaces

[knmij1234]

Hi,

I worked through a VMware and vWAAS install on a new UCS-E SM module for a Cisco 2900-series router.  Everything went fine with the IMC and MGF configs and the VMware and vWAAS builds.  When I removed that module from my lab router and installed it in my production 2951 router, at bootup I get the ucse1/0 interface, but I do NOT get a ucse1/1 interface to host the L2 trunk.

How can I resolve this issue?

Thank you

[Reza Sharifi · Accepted solution]

Hi,

Make sure the production router is running the same IOS as the lab router.

HTH

[knmij1234]

Both routers are running supported 15.4 code.

[Reza Sharifi]

Is the lab device a 2951 as well?