Hi All,
I'm having weird problems with both of our 3560G switches. When I take a look at the port statistics via CNA I see a lot of underzised errors on trunk ports.
When I take a look at the CLI via sh interfaces counters errrors I don't see any underzised errors.
I know that this was a software bug in several versions, but we are running 12.2(52)SE and as far as I know that isn't an issue with this version.
The configuration of the ports are like this:
interface GigabitEthernet0/4
description Uplink to SWIBLA06 Port 22 Slot 6
switchport trunk encapsulation dot1q
switchport mode trunk
switchport nonegotiate
speed 1000
duplex full
channel-protocol lacp
channel-group 6 mode passive
spanning-tree portfast trunk
end
SWICOR02#sh run int gig0/3
Building configuration...
Current configuration : 276 bytes
!
interface GigabitEthernet0/3
description Uplink to SWIBLA06 Port 21 Slot 6
switchport trunk encapsulation dot1q
switchport mode trunk
switchport nonegotiate
speed 1000
duplex full
channel-protocol lacp
channel-group 6 mode passive
spanning-tree portfast trunk
these are uplinks to a GBE2c switch in a HP Chassis
Does this problem sound familiar to anyone?
Thanks!
Geert Reijnders
