06-19-2017 04:20 AM - edited 03-08-2019 11:01 AM
Hi!
I have upgraded ROM on cisco WS-C4506-E. I can see on show version that its point to right version.
ROM: 12.2(44r)SG10
But when I run show module I can see is its saying something different.
Hw Fw Sw Status
--+--------------------------------+---+------------+----------------+---------
1 0016.0bd0.2c80 to 0026.0bf0.2c85 1.4 12.2(44r)SG1 12.2(54)SG1 Ok
Can anyone confirm if the ROM upgrade is fine so that I can upgrade the IOS?
Thanks
Solved! Go to Solution.
06-19-2017 04:27 AM
You should be fine. The output of the "sh version" will show the ROMmon of the supervisor card. The output of the "sh module" will show the IOS version of the different line cards.
06-19-2017 04:27 AM
You should be fine. The output of the "sh version" will show the ROMmon of the supervisor card. The output of the "sh module" will show the IOS version of the different line cards.
06-19-2017 06:37 AM
ok Thanks for your reply. So I am good to go with the IOS upgrade :).
11-18-2017 07:22 PM
Hello, we have the same problem. In our case upgrade was performed to rommon 12.2(44r)SG10 on WS-C4507R-E with dual sup config. How can we check if both supervisors are running right rommon version?
Sh version is showing SG10, but it's only for active sup, right? Are there any different show commands to confirm rommon version in both supervisors?
Thanks
Btw that different output from sh mod seems like bug, or some sort of limit to only 13 characters.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide