11-03-2014 12:02 AM - edited 03-07-2019 09:20 PM
i am not that much familiar but i can do little bit, actually i am confused here how to connect UTP cables and how to configure Trunk.
there is attach jpg file for clear scenario
i have 4 Switches cisco 2960-S series
3 switches 48 Ports
1 switch 24 Ports
i want to up-link all 4 switches and configure trunk, so that all switches act like a one switch
i want steps to do it.
thanking you for your help!
11-03-2014 05:15 AM
To achieve your objective, you would need to configure a 'stack', which you can do with your switches (this is what the 'S' denotes)
There are special cables that are required to do this, if you look at the back of the switch you will see the interface.
Martin
11-04-2014 03:49 AM
As said above, you need to plug the stack cables into them as per the guide below:
http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst2960/hardware/installation/guide_stack/2960SHIG/HIGINSTL.html
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide