cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1344
Views
0
Helpful
1
Replies

VIP used as gateway on Nexus switch: Can't be used in extended ping?

Dmoreno69
Level 1
Level 1

Hello,

I am troubleshooting an issue about connectivity to a couple boxes.

We have two Nexus switches. From one I can ping the 2 boxes but their MAC address is not shown when I issue "show ip arp [IP_address]".

On the other switch, I see the MAC addresses but cannot ping.

On the switch that ping works, the SVI for the 2 boxes is administratively down (currently investigating the reason why it was disabled). Then the echo requests are being forwarded thru the switch default gateway? Assuming so and to confirm I did a extended ping to one of the boxes, source IP address was the switch default gateway which happens to be a HSRP Virtual Address. Ping succeded, actually it worked when pinging with another ViP as source

On the switch where I can see the servers MAC addresses, I tried the same extended ping (usings the respective default gateway and another ViP), an error message: invalid source address, was returned.

Why this different behavour on 2 peer devices?

Thanks in advance!

SwitchA# show run | i gateway

  peer-gateway

      ip default-gateway 10.42.63.131

      ip default-gateway 10.42.63.131

SwitchB# show run | i gateway

  peer-gateway

      ip default-gateway 10.42.63.131

      ip default-gateway 10.42.63.131

-----------------------------------------------------------------------------------------------------------

Ping from Switch A

Extended commands [no] : yes

Source address or interface : 10.42.63.131

Sending 5, 56-bytes ICMP Echos to 10.42.28.41

Timeout is 2 seconds, data pattern is 0xABCD

64 bytes from 10.42.28.41: icmp_seq=0 ttl=127 time=15.704 ms

64 bytes from 10.42.28.41: icmp_seq=1 ttl=127 time=1.288 ms

Ping from Switch B   

Target IP address or Hostname: 10.42.28.41

Extended commands [no] : yes

Source address or interface : 10.42.63.131

% Invalid source address

-----------------------------------------------------------------------------------------------------------

1 Reply 1

Fabienne Stephanoff
Cisco Employee
Cisco Employee

Hello David,

We would prob need to do an ELAM on the N7K (assuming this is a 7000) to check the programming via webex. Can you please open a TAC case?

Fabienne

TAC

Review Cisco Networking for a $25 gift card