VLAN Interface on layer 2 switch

[Rem Markov]

Hey ! So I have configured an eve-ng lab.

I have a cloud which what connects me to the bridge (My network).

To the bridge I have connected a router and a switch (Cisco IOL L3 and L2).

My router automatically received an IP address.

On the switch I have configured Vlan 10 interface with a static IP address of the network and added the default gateway as the router as they both connected to the same router. 

However I can't ping out or in the switch. I have tried configuring the VLAN10 on the e0/0 (the port that connects to to the cloud) and still nothing. 

 

 

Help please ?

[Rem Markov]

 The configuration on the port on the switch

[Martin L]

can't really see anything; picture too small; copy and paste your configs directly from cli window here; and write topology u have , et. Cloud > IOL switch > IOL rotuer ?

Note: using Cisco IOL L3 and L2 outside of CML may not work and it is illegal to do so !

Regards, ML
**Please Rate All Helpful Responses **

[Rem Markov · Accepted solution]

Actually I solved it, I need to put on the interface I want to work, switchport mode access , and then switchport vlan <Vlan-id of the vlan interface I want>

There problem was is that i set it as trunk instead of access.