02-10-2017 12:05 AM - edited 03-08-2019 09:16 AM
Hello,
Can someone please let me know if you have tried the following connectivity. Does it works fine?
- Each 3750X in stack will connect to both the Nexus switches in vPC . Attached is the connectivity diagram
Regards,
Prakash Matuwani
Solved! Go to Solution.
02-10-2017 01:28 AM
that's the way we have it built in po , both of them , peer-link in another po too
interface port-channel100
description VPC Heartbeat
logging event port link-status
vrf member heartbeat
ip address x.x.x.x/x
peer-keepalive destination x.x.x.x source x.x.x.x vrf heartbeat
100 Po100(RU) Eth NONE Eth3/46(P) Eth4/46(P)
02-10-2017 12:26 AM
Hi
Yes that's no problem , just on the switch end though it will be port-channel and on the Nexus side a VPC , as it stacked though do you really need that much cabling , just connect one link of the po to one switch and the 2nd to say the bottom switch so its across the stack to give redundancy
02-10-2017 01:11 AM
Hi Mark,
Thanks for your reply.
Yes, we have one connection between 3750 and Nexus as follows
first 3750X ---> first Nexus
second 3750X ---> second Nexus
Was just thinking if i can have more resiliency.
Regards,
Prakash Matuwani
02-10-2017 01:17 AM
Hi
yes understand resiliency is key to good setup ,you could also just add a couple of extra links to the 1 vpc rather than doubling up on vpcs on same switch , im just thinking if something does eventually go wrong it will be a lot easier to tshoot with 1 vpc than 2 coming off same stack but both ways should work for you , you would definitely want the pos cabled like the diagram too split across both nexus switches
02-10-2017 01:23 AM
Hi Mark,
I have one more question not completely related to this discussion.
Have you tried creating vPC KEEPALIVE link as L3 port-channel?
I read many cisco documents and config guide to find the answer but everywhere the keepalive link is mentioned as a single connection. vPC peer link is in port-channel but not the keepalive.
Regards,
Prakash Matuwani
02-10-2017 01:28 AM
that's the way we have it built in po , both of them , peer-link in another po too
interface port-channel100
description VPC Heartbeat
logging event port link-status
vrf member heartbeat
ip address x.x.x.x/x
peer-keepalive destination x.x.x.x source x.x.x.x vrf heartbeat
100 Po100(RU) Eth NONE Eth3/46(P) Eth4/46(P)
02-10-2017 01:44 AM
Thanks for sharing the information.
Regards,
Prakash Matuwani
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide