vPC Nexus error LACP with Switch Access

[VuongNguyen2903]

Hi everyone,

You may give the solution for checking and fixing?

I configured vPC member port on 2 Nexus connect Cisco WS-C3850-48P:

On Cisco WS-C3850-48P:

interface GigabitEthernet2/0/17
switchport mode trunk
channel-protocol lacp
channel-group 103 mode active

!
interface Port-channel103
switchport mode trunk

On Nexus:

interface Ethernet1/36
switchport mode trunk
channel-group 40 mode active

interface port-channel40
switchport mode trunk
vpc 103

and show log:

%EC-5-L3DONTBNDL2: Gi1/1/17 suspended: LACP currently not enabled on the remote port

[marce1000]

 - You may need to set Port-channel103 on the C3850 in channel mode too , check output of sh etherchan summary (for instance) ,  find out if the 'global portchannel' is seen in the output  , 

 M.

[VuongNguyen2903]

Tks for your support

[MHM Cisco World]

Are you complete config  vpc domain in both nsk?

Are you run feature lacp in both nsk

Are you use same stp mode in sw and both nsk?

[VuongNguyen2903]

vPC had established. Feature enabled in both nsk. 3 device the same mode stp is RSTP. You can give me to advice

[MHM Cisco World]

Share 

Show port-channel summary 

Show stp 

[marce1000]

            - Also include :  sh etherchan summary 

 M.