Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone,I practice the Lab on Pnetlab. Connect 2 Nexus and configuration Port channel.I have issue with the information: I configure Channel Po10 for 2 Nexus on both e1/1 port. version 9.3(4) Bios:versioninterface Ethernet1/1switchport mode trunk...
Hi everyone,You may give the solution for checking and fixing?I configured vPC member port on 2 Nexus connect Cisco WS-C3850-48P:On Cisco WS-C3850-48P:interface GigabitEthernet2/0/17switchport mode trunkchannel-protocol lacpchannel-group 103 mode act...
Hi everyone,I have a question for vPC of paramater. It is vPC card type. What does this mean? I can configure to change it or it's related with hardware and not change? Thank you for your support.#show vpc consistency-parameters vpc 25vPC card type ...
I'm newbie. Please, Everyone can help me fix:ERROR | Failed to apply service configuration at "SCE 2000 []": SparseArray dimension 0 index 3I'm using SCA BB Console so that apply service configuration to SCE 2000.Thank you!
Thank you for your support.seem the lab is bug. I don't certainly. I have to connect the link before I start device such I can configure port channel to success.
version 9.3(9) Bios:versioninterface port-channel10switchport mode trunkspeed 100001(config-if)# show run int e1/1!Command: show running-config interface Ethernet1/1!Running configuration last done at: Thu Apr 6 02:06:06 2023!Time: Thu Apr 6 02:06:17...
