cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
138
Views
0
Helpful
1
Replies
Highlighted
Beginner

VSS Configuration on C4500X seems to be erroneous

Hello Team Members

Recently we established VSS between C4500X chassis (WS-C4500X-16SFP+) . Everything is working normal. 

Both units are logically bundled,  there is no issue a far as traffic flow is concerned, however after Chassis merged into 

one, Port-channel 2 configuration (defined earlier on Chassis 2) is changed by its own. Before VSS , Port-channel 2 was having the following config .

interface Port-channel2
 switchport
 switchport mode trunk
 switchport nonegotiate
 switch virtual link 1
---------------------------------------------------------------------

but after VSS, 2 commands are removed on its own on Port-channel 2

interface Port-channel1
 switchport
 switchport mode trunk
 switchport nonegotiate
 switch virtual link 1
!
interface Port-channel2
 switchport
 switch virtual link 2
!

--------------------------------------------

is it a bug, we are running Catalyst 4500 L3 Switch  Software (cat4500e-UNIVERSALK9-M), Version 03.07.00.E RELEASE SOFTWARE (fc4)

Any Inputs are highly appreciated.

Thanks

Ahad

 

1 ACCEPTED SOLUTION

Accepted Solutions
Rising star

Hey mansoor,May be hitting

Hey mansoor,

May be hitting one of the following bugs.

CSCur07401

CSCus77443

 

hope this helps

Please rate helpful posts,

Thanks

1 REPLY 1
Rising star

Hey mansoor,May be hitting

Hey mansoor,

May be hitting one of the following bugs.

CSCur07401

CSCus77443

 

hope this helps

Please rate helpful posts,

Thanks

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards