VSS Support Module.

[muhsinamol]

Dear Support,

I have 6506-E  chassis and card type CEF 720 16 10GE  with model WS-6716-GE  and distributed forwarding card  WS-F6700-DFC3C and IOS Version 12.2(33)SXI4a.

Can I know  this module and IOS version will support VSS implementation.

I have sup 720  installed in my Chassis.

Regards

Musinamol

[Jon Marshall]

Musinamol

What is the exact model of supervisor ?

Jon

[muhsinamol]

Dear Jon,

Thanks for you reply, please find the sh module details below and advice me.

SWILSC-CO-02#sh module
Mod Ports Card Type                              Model              Serial No.
--- ----- -------------------------------------- ------------------ -----------
  1   48  CEF720 48 port 1000mb SFP              WS-X6748-SFP       SAL150354RV
  2   16  CEF720 16 port 10GE                    WS-X6716-10GE      SAL14491XRH
  3   48  CEF720 48 port 1000mb SFP              WS-X6748-SFP       SAL13495TJ1
  5    5  Supervisor Engine 720 10GE (Active)    VS-S720-10G        SAL15024ST5

Mod MAC addresses                       Hw    Fw           Sw           Status
--- ---------------------------------- ------ ------------ ------------ -------
  1  503d.e56f.1ab8 to 503d.e56f.1ae7   2.4   12.2(18r)S1  12.2(33)SXI4 Ok
  2  1cdf.0ffd.34e8 to 1cdf.0ffd.34f7   1.0   12.2(18r)S1  12.2(33)SXI4 Ok
  3  588d.097c.7cac to 588d.097c.7cdb   2.4   12.2(18r)S1  12.2(33)SXI4 Ok
  5  c47d.4ffe.8aa8 to c47d.4ffe.8aaf   4.0   8.5(4)       12.2(33)SXI4 Ok

Mod  Sub-Module                  Model              Serial       Hw     Status
---- --------------------------- ------------------ ----------- ------- -------
  1  Distributed Forwarding Card WS-F6700-DFC3C     SAL15045PA8  1.4    Ok
  2  Distributed Forwarding Card WS-F6700-DFC3C     SAL14502BK2  1.4    Ok
  3  Distributed Forwarding Card WS-F6700-DFC3C     SAL1640NUA8  1.5    Ok
  5  Policy Feature Card 3       VS-F6K-PFC3C       SAL15035EQ5  1.1           Ok
  5  MSFC3 Daughterboard         VS-F6K-MSFC3       SAL15045GCS  5.1     Ok

Regards

Muhsinmol

[Jon Marshall]

You should be fine with what you have.

See this link for more details, there is a table showing both the hardware and software requirements -

http://www.cisco.com/c/en/us/products/collateral/switches/catalyst-6500-virtual-switching-system-1440/prod_qas0900aecd806ed74b.html

if you have any more queries please come back.

Jon

[muhsinamol]

Thanks to all for you valuable  support.

[InayathUlla Sharieff]

I agree with John.

The modules which you have on this chasis should be good to go for VSS.

HTH

Regards

Inayath