VTP Settings

[Manish Manwal]

we create our core switch(3850) as a vtp server. and all of switches in client mode( 3650, 2960-i, 2960-l)

some of these switch shows me that there have vtp version 3 and can not set version 2.

after that we set all switches vtp version as 3. but when we create some vlan on our core switch that is vtp server vlan can not distribute all of the switch.

where is the problem.?????

[Dhanamjay.p]

Hello,

Can you confirm all those Switches interconnected interfaces are in Trunk mode.

And all switches are in same VTP domain and password (if there).

Regards,

Dhanamjay.

[Manish Manwal]

yes there connected link in trunk. they are in same domain. and they have same password.
trunk because many vlan configured on switches.

[dhanamjay]

can you share me below output from core switch as well as from one neighbour switch where VLAN propagation is not happening.

and vlan ID details which you created on core recently

Sh vtp status
and sh run int xx (interconnected interface's from both devices)
sh switchport interface xx

[Manish Manwal]

now its working ..