Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
621
Views
0
Helpful
4
Replies

WAN router with failover to external VPN device

Go to solution
fbarnett
Level 1
Level 1

‎03-31-2009 01:15 PM - edited ‎03-06-2019 04:55 AM

Cisco 2811 with MPLS running RIPv2. What is the best way to configure VPN failover to another device (Juniper SSG-350) that is on the same LAN? Is this as simple as weighted static route?

Labels:
0 Helpful
1 Accepted Solution

Accepted Solutions

Go to solution
Thotsaphon Lueangwattanaphong
Level 7
Level 7
In response to fbarnett

‎03-31-2009 01:27 PM

Chip,

It was my typo again. It should be look like this:

ip route 20.0.0.0 255.0.0.0 10.100.100.1(Juniper) 130(AD)

HTH,

Toshi

View solution in original post

0 Helpful
4 Replies 4

Go to solution
Thotsaphon Lueangwattanaphong
Level 7
Level 7

‎03-31-2009 01:19 PM

Chip,

Just add static routes pointing to Juniper with higher AD than RIP. This should be fine.

HTH,

Toshi

0 Helpful

Go to solution
fbarnett
Level 1
Level 1
In response to Thotsaphon Lueangwattanaphong

‎03-31-2009 01:21 PM

Thanks for the quick response, what did you mean by "then RIP" ?

Thanks!

0 Helpful

Go to solution
Thotsaphon Lueangwattanaphong
Level 7
Level 7
In response to fbarnett

‎03-31-2009 01:27 PM

Chip,

It was my typo again. It should be look like this:

ip route 20.0.0.0 255.0.0.0 10.100.100.1(Juniper) 130(AD)

HTH,

Toshi

0 Helpful

Go to solution
fbarnett
Level 1
Level 1
In response to Thotsaphon Lueangwattanaphong

‎03-31-2009 01:29 PM

ok, understand

Thanks for the quick help.

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking for a $25 gift card