03-31-2009 01:15 PM - edited 03-06-2019 04:55 AM
Cisco 2811 with MPLS running RIPv2. What is the best way to configure VPN failover to another device (Juniper SSG-350) that is on the same LAN? Is this as simple as weighted static route?
Solved! Go to Solution.
03-31-2009 01:27 PM
Chip,
It was my typo again. It should be look like this:
ip route 20.0.0.0 255.0.0.0 10.100.100.1(Juniper) 130(AD)
HTH,
Toshi
03-31-2009 01:19 PM
Chip,
Just add static routes pointing to Juniper with higher AD than RIP. This should be fine.
HTH,
Toshi
03-31-2009 01:21 PM
Thanks for the quick response, what did you mean by "then RIP" ?
Thanks!
03-31-2009 01:27 PM
Chip,
It was my typo again. It should be look like this:
ip route 20.0.0.0 255.0.0.0 10.100.100.1(Juniper) 130(AD)
HTH,
Toshi
03-31-2009 01:29 PM
ok, understand
Thanks for the quick help.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide