cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
531
Views
0
Helpful
2
Replies

WCCP issue in Cisco 4900

CSCO11357378
Level 1
Level 1

Hi all

I am try to configurate WCCP in a Cisco 4900 device but I can´t do it, appear the following error:

Packet forwarding mismatch (The router does not support the forwarding method (GRE or L2)

This is our IOS version

Cisco IOS Software, Catalyst 4500 L3 Switch Software (cat4500e-ENTSERVICESK9-M), Version 15.0(2)SG9, RELEASE SOFTWARE (fc2)

Any Idea?, Can you help me?

Regards

1 Accepted Solution

Accepted Solutions

Reza Sharifi
Hall of Fame
Hall of Fame

Hi,

Do you have any SVI or layer-3 interface enabled?

Not sure if this is your issue or not:

  • Global WCCP service configuration fails to enable (WCCP global config is accepted but nvgen fails) on a newly deployed switch if the switch is not enabled for SVI or a Layer 3 interface.

Workaround: Enable a Layer 3 interface in the running config. CSCsc88636.

Link:

http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4500/release/note/ol-1523e-4900m-4948e.html

HTH

View solution in original post

2 Replies 2

Reza Sharifi
Hall of Fame
Hall of Fame

Hi,

Do you have any SVI or layer-3 interface enabled?

Not sure if this is your issue or not:

  • Global WCCP service configuration fails to enable (WCCP global config is accepted but nvgen fails) on a newly deployed switch if the switch is not enabled for SVI or a Layer 3 interface.

Workaround: Enable a Layer 3 interface in the running config. CSCsc88636.

Link:

http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4500/release/note/ol-1523e-4900m-4948e.html

HTH

CSCO11357378
Level 1
Level 1

Hi Reza

This router is working as a layer-3 currently, any other idea?, Could be a version issue?

Regards

Review Cisco Networking for a $25 gift card