cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
186
Views
0
Helpful
2
Replies
Beginner

What is the average value of the cisco catalyst 2960 sfp transceiver?

Hello,

 

We have a few catalyst 2960 with SFP-10GBase-SR sfp moduls. The PRTG send me a warning message, that the value is too low. If I check on the swtch via Sh int transceiver I can see the value (I attached the screenshot) 

But the PRTG table say -2,50 (1066) is above the warning limit of -14 in 1066. 

 

What should I do?

Try to renoumber on the PRTG sensor?

 

Thanks,

Tamas

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Expert

Re: What is the average value of the cisco catalyst 2960 sfp transceiver?

Hi,

If the optic is working fine for you, just disable the alert on PRTG or modify the threshold so you don't get that message.

 

HTH

2 REPLIES 2
VIP Expert

Re: What is the average value of the cisco catalyst 2960 sfp transceiver?

Hi,

If the optic is working fine for you, just disable the alert on PRTG or modify the threshold so you don't get that message.

 

HTH

Highlighted
Beginner

Re: What is the average value of the cisco catalyst 2960 sfp transceiver?

Yes, It work fine. I think the cable is dirty. So everything is alright :D
CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards