Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All, Our customer has CUCM ver. 11.0.1.20000-2. I would like to register two different phones, but I should uprage these phones Firmware.What is the recommended Firmware at these phones?The phones type are 7940 SCCP and 8845 SIP. Thank you,Kind...
Hello Everyone, I got many snmp alert from WS-C4500X-32, for example Te1/1/2 Optical RX is to low (-40).Which is wired, I have never connected SFP modul at this port, and the ports config is empty.But, if I checked the inventory the switch says the S...
Hello Everyone, We installed CIsco ip telephones to CICM. The phone can be able to join to CICM. I can call the inside CM server, and I can record voices. But the agents can't login on the phone. If we go to settings --> login the phone sent udp requ...
Hello,
We have a few catalyst 2960 with SFP-10GBase-SR sfp moduls. The PRTG send me a warning message, that the value is too low. If I check on the swtch via Sh int transceiver I can see the value (I attached the screenshot)
But the PRTG table say...
Hi All,
I would like to create a database. We work with a lot of Cisco model (Asa, switch, router, ap, etc..) I collect the switches and its interface's name.
Forexample: WS-C2960X-48LPS-L
!
interface FastEthernet0
!
interface GigabitEthernet1/0/1 ...
I mean, this phone version (3.03) is too old, and the phone cannot register the CUCM. I should upgrade the FW.But is the latest FW phone can register at the CUCM?
