cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
593
Views
0
Helpful
2
Replies

What is the average value of the cisco catalyst 2960 sfp transceiver?

Szabo Tomi
Beginner
Beginner

Hello,

 

We have a few catalyst 2960 with SFP-10GBase-SR sfp moduls. The PRTG send me a warning message, that the value is too low. If I check on the swtch via Sh int transceiver I can see the value (I attached the screenshot) 

But the PRTG table say -2,50 (1066) is above the warning limit of -14 in 1066. 

 

What should I do?

Try to renoumber on the PRTG sensor?

 

Thanks,

Tamas

1 Accepted Solution

Accepted Solutions

Reza Sharifi
Hall of Fame Expert Hall of Fame Expert
Hall of Fame Expert

Hi,

If the optic is working fine for you, just disable the alert on PRTG or modify the threshold so you don't get that message.

 

HTH

View solution in original post

2 Replies 2

Reza Sharifi
Hall of Fame Expert Hall of Fame Expert
Hall of Fame Expert

Hi,

If the optic is working fine for you, just disable the alert on PRTG or modify the threshold so you don't get that message.

 

HTH

Yes, It work fine. I think the cable is dirty. So everything is alright :D
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers