cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
547
Views
0
Helpful
1
Replies

which command can show VLAN and forwarding state at the same time?

martlee2
Cisco Employee
Cisco Employee

which command can show for searching this

"if you see two ports in a forwarding state for the same VLAN on the same switch"

1 Reply 1

Mark Malone
VIP Alumni
VIP Alumni

if i get what your saying correctly below shows the vlan and its fwd ports

show spanning-tree vlan x

#sh spanning-tree vlan 32

VLAN0032
  Spanning tree enabled protocol rstp
  Root ID    Priority    4128
             Address     xxxxxxxxxxxxxxxx
             This bridge is the root
             Hello Time   2 sec  Max Age 20 sec  Forward Delay 15 sec

  Bridge ID  Priority    4128   (priority 4096 sys-id-ext 32)
             Address     xxxxxxxxxxx
             Hello Time   2 sec  Max Age 20 sec  Forward Delay 15 sec
             Aging Time 14400

Interface           Role Sts Cost      Prio.Nbr Type
------------------- ---- --- --------- -------- --------------------------------
Po32                Desg FWD 3         128.5764 P2p
Po34                Desg FWD 3         128.5765 P2p
Po122               Desg FWD 1         128.5770 P2p
Po123               Desg FWD 4         128.5771 P2p
Po124               Desg FWD 1         128.5772 P2p
Po127               Desg FWD 1         128.5773 P2p

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: