Buy or Renew
Buy or Renew
NOTICE: You can now engage in the community. Learn about the great new Cisco Umbrella content.

Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation

Get 20% off switches when you combine Cisco solutions

 
Labels

Forum Posts

Start a conversation

3550 - How do you delete a subdir in Flash?

Hi, I successfully updated the IOS on a 3550 but cannot delete the dir that housed the old IOS.Here's what I tried:Switch#rmdir c3550-i9q3l2-mz.121-22.EA4Remove directory filename [c3550-i9q3l2-mz.121-22.EA4]?Delete flash:c3550-i9q3l2-mz.121-22.EA4?...

troyheiss by • Level 1
  • 10707 Views
  • 7 replies
  • 0 Helpful votes

Resolved! Disable Inter-VLAN Communication

Hi, We have a 3750 which act as our core router and several 2960s and 4948 as L2 device. We have 3 VLANs (10-data 172.18.80.0, 20-voice 172.18.82.1 and 30-wifi 192.175.31.0 dot1x).Wifi is set up to authenticate to the DC with the same subnet but the ...

Gentry by • Level 1
  • 5857 Views
  • 4 replies
  • 0 Helpful votes

Resolved! Cisco 7960 IP Phone registers, but doesn't receive a number

Can't figure out what's wrong, but our 7. phone doesn't receive a phone number.  ******************************************************************************************* telephony-service max-ephones 14 max-dn 14 ip source-address 192.168.0.1 port...

kip by • Level 1
  • 354 Views
  • 3 replies
  • 0 Helpful votes

ip directed-broadcast over GRE?

Hello Is it possible in the above setup, to let Server A in site A send a directed broadcast to vlan 20 subnet in site B ? What is the configuration needed to let this happen? I've tried to enable the ip directed-broadcast command on all the L3 int...

Resolved! Occasional Peaks on AFM and statsclient process

Hi, One of N5K is experiencing occasional peaks on afm and statsclient process.  PID    Runtime(ms)  Invoked   uSecs  1Sec    Process-----  -----------  --------  -----  ------  -----------3218    665924076  317362594   2098   43.3%  statsclient3064 ...

myat.thu1 by • Level 1
  • 1341 Views
  • 1 replies
  • 0 Helpful votes

Resolved! shaping the real time traffic

Hello, As i know from practice it's best to police the real time traffic (e.g voip). But do it's possible to use shaping for this type of traffic class ? do the delay from shaping would impact the voice call quality ? Thanks..

from88 by • Level 4
  • 671 Views
  • 6 replies
  • 0 Helpful votes

udld fail ?

Dear experts I've a Cisco 6500 (12.2(33)) connected to a juniper EX with a 2 x 10Gb port channel. Apparently the Cisco gear has disabled one out of the two ten giga interface after some flapping of the other one and due to UDLD that is currently non...

Resolved! Cisco 3925 Power cutover one by one

Hi all, good day. Recently I've connected two power cords of one Cisco 3925 to two power sockets on wall due to UPS issue -- downtime happened. I was thinking once the UPS got fixed and sent back is it possible to connect  one power cord back to UPS...

View All
Review Cisco Networking for a $25 gift card