I was applying policing command to an input policy in my 6509 switch and get the following message in bold. I could do the same thing in my c3560 switch. can someone tell me why? I attached "show ver, and show module". Eventually I need to apply policing command to my production 6513 switch.
I also tried police cir and police rate and got the same message. Any input will be appreciated.
thanks, Alison
Lab6509(config)#policy-map QOS-LAN
Lab6509(config-pmap)#class LOWPRIORITY
Lab6509(config-pmap-c)#POLICe 2000000
Addition made to policymap QOS-LAN and class LOWPRIORITY is not valid, command is rejected
Lab6509(config-pmap-c)#
Lab6509(config-pmap-c)#police cir 2000000
Addition made to policymap QOS-LAN and class LOWPRIORITY is not valid, command is rejected
Lab6509(config-pmap-c)#polic
Lab6509(config-pmap-c)#police rate
Lab6509(config-pmap-c)#police rate 2000000?
WORD
Lab6509(config-pmap-c)#police rate 2000000 ?
bps Treat 'rate' value in bits-per-second
burst Specify 'burst' parameter
conform-action action when rate is less than conform burst
peak-rate Specify peak rate or PCR for single-level ATM 4.0 policer policies
<cr>
Lab6509(config-pmap-c)#police rate 2000000
Addition made to policymap QOS-LAN and class LOWPRIORITY is not valid, command is rejected
Lab6509(config-pmap-c)#
Lab6509#sh ver
Cisco IOS Software, s72033_rp Software (s72033_rp-IPSERVICES-M), Version 15.1(2)SY, RELEASE SOFTWARE (fc4)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2013 by Cisco Systems, Inc.
Compiled Wed 04-Sep-13 13:05 by prod_rel_team
ROM: System Bootstrap, Version 12.2(17r)S2, RELEASE SOFTWARE (fc1)
Lab6509 uptime is 6 weeks, 4 days, 19 hours, 4 minutes
Uptime for this control processor is 6 weeks, 4 days, 19 hours, 0 minutes
System returned to ROM by power cycle at 08:30:10 PDT Thu Oct 17 2013 (SP by power on)
System restarted at 13:40:08 PDT Wed Jun 18 2014
System image file is "disk0:s72033-ipservices-mz.151-2.SY.bin"
Last reload reason: abort at PC 0x425EAE74
cisco WS-C6509 (R7000) processor (revision 3.0) with 458720K/65536K bytes of memory.
Processor board ID TBM06243664
SR71000 CPU at 600Mhz, Implementation 0x504, Rev 1.2, 512KB L2 Cache
Last reset from power-on
11 Virtual Ethernet interfaces
192 FastEthernet interfaces
20 Gigabit Ethernet interfaces
1917K bytes of non-volatile configuration memory.
65536K bytes of Flash internal SIMM (Sector size 512K).
Configuration register is 0x2002
Lab6509#sh modeul
Lab6509#sh modul
Lab6509#sh module
Mod Ports Card Type Model Serial No.
--- ----- -------------------------------------- ------------------ -----------
1 48 48 port 10/100 mb RJ45 WS-X6348-RJ-45 SAL06220EUY
2 48 48 port 10/100 mb RJ45 WS-X6348-RJ-45 SAL06211171
3 48 48 port 10/100 mb RJ45 WS-X6348-RJ-45 SAL06220EUB
4 48 48 port 10/100 mb RJ45 WS-X6348-RJ-45 SAL0538BTT2
5 2 Supervisor Engine 720 (Active) WS-SUP720-BASE SAL094027BH
6 2 Supervisor Engine 720 (Hot) WS-SUP720-BASE SAL09475LE8
9 16 16 port 1000mb GBIC ethernet WS-X6416-GBIC SAL06200UTZ
Mod MAC addresses Hw Fw Sw Status
--- ---------------------------------- ------ ------------ ------------ -------
1 0009.1278.0780 to 0009.1278.07af 6.1 5.4(2) 15.1(2)SY Ok
2 0009.1278.01b0 to 0009.1278.01df 6.1 5.4(2) 15.1(2)SY Ok
3 0009.1278.0e10 to 0009.1278.0e3f 6.1 5.4(2) 15.1(2)SY Ok
4 0005.9a8e.6d60 to 0005.9a8e.6d8f 5.3 5.4(2) 15.1(2)SY Ok
5 0013.7f0d.a3cc to 0013.7f0d.a3cf 3.3 8.1(3) 15.1(2)SY Ok
6 0014.a97e.1870 to 0014.a97e.1873 3.3 8.1(3) 15.1(2)SY Ok
9 0009.1266.6cf0 to 0009.1266.6cff 2.2 5.4(2) 15.1(2)SY Ok
Mod Sub-Module Model Serial Hw Status
---- --------------------------- ------------------ ----------- ------- -------
1 Inline Power Module WS-F6K-VPWR 1.0 Ok
2 Inline Power Module WS-F6K-VPWR 1.0 Ok
3 Inline Power Module WS-F6K-VPWR 1.0 Ok
5 Policy Feature Card 3 WS-F6K-PFC3A SAL09391MNS 2.5 Ok
5 MSFC3 Daughterboard WS-SUP720 SAL094027HG 2.5 Ok
6 Policy Feature Card 3 WS-F6K-PFC3A SAL094650W8 2.5 Ok
6 MSFC3 Daughterboard WS-SUP720 SAL094652GV 2.5 Ok
Mod Online Diag Status
---- -------------------
1 Pass
2 Pass
3 Pass
4 Pass
5 Pass
6 Pass
9 Pass
