11-02-2010 08:17 AM - edited 03-06-2019 01:50 PM
Hi there
I have inherited a switch stack as follows:
Switch# Role Mac Address Priority Version State
----------------------------------------------------------
*1 Master 04fe.7f0d.2280 1 0 Ready
2 Member 0000.0000.0000 0 0 Provisioned
3 Member ec44.76e5.7980 1 0 Ready
4 Member 0064.40aa.2200 1 0 Ready
UK01SW47#sh swi stack-p
Switch # Port 1 Port 2
-------- ------ ------
1 Down Ok
3 Ok Ok
4 Ok Down
UK01SW47#sh swi nei
Switch # Port 1 Port 2
-------- ------ ------
1 None 3
3 4 1
4 3 None
I need to remove switch 1 and just stack the current switch 3 & 4.
I intend to
a: power off switch 1. This should cause a master election between 3 & 4.
b: connect stack cable between switch 3 port 2 and switch 4 port 2 to enable a full duplex redundant connection.
I would like to remove switch 1 and 2 from the configuration with:
no switch 2 provision ws-c3750g-48ts
no switch 1 provision ws-c3750g-48ts
Will this cause the switch stack to reload.
As this is a production system I hope it wont
Thanks for you expected help
Regards
Richard
Solved! Go to Solution.
11-02-2010 11:33 AM
Hi Richard,
You should be good. The switch stack should not reload after removing the two unprovisioned switches.
JayaKrishna
11-02-2010 11:33 AM
Hi Richard,
You should be good. The switch stack should not reload after removing the two unprovisioned switches.
JayaKrishna
11-02-2010 08:56 PM
Sure but switch numbering will be puzzling to the un-initiated.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide