Hi All,
I am currently using a switch
- WS-C2960S-24PS-L
- IOS: Cisco IOS Software, C2960S Software (C2960S-UNIVERSALK9-M), Version 12.2(55)SE7, RELEASE SOFTWARE (fc1)
For connect two network between voip Cameras and workstation, So I configured SVI that act as a default gateway for both network and make them see each other.
But now, the management system want those network be reachable form the corp network and viceversa.
So I was thinking I can create a routing port on the switch, assign it an IP address and then create and ip route and send all the traffic for those network out of gi0/24. But I am not sure the switch has the capability to have this command. (I don't have access to the switch right now, but I want to be prepared.)
This is additional Info.
Video Network. 192.168.X.X
Workstation Network. 10.200.50.X
interface Vlan1
ip address 192.168.192.254 255.255.255.0 secondary
ip address 192.168.191.254 255.255.0.0
!
interface Vlan2
ip address 10.200.50.220 255.255.254.0
These are the network I have to reach.
10.15.22.51 255.255.254.0, 10.15.22.254
10.14.91.9 255.255.255.0, 10.14.91.254
10.14.90.9 255.255.255.0, 10.14.90.254
10.14.89.9 255.255.255.0, 10.14.89.254
10.14.93.8 255.255.255.0, 10.14.93.254
10.14.93.38 255.255.255.0, 10.14.93.254
I was thinking to create an IP route command for all those subnets, can someone tell me that is achievable with only static routing and, tell me I the 2960 switch can do that.
PFA the show run of the Cisco switch.
