WS-C6513 - Is there a way to make sure that a particular line module comes up first

[rashmi.patel]

During boot up I want module 12 to come up first because other infrastructure network devices are connected to it.

Is there a way to prioritise the order in which the line modules boot up?

------------------ show module ------------------

Mod Ports Card Type                              Model              Serial No.

--- ----- -------------------------------------- ------------------ -----------

  1   48  SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-45AF   SAL1109JDTW

  2   48  SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-45AF   SAL1051BQDC

  3   48  SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-45AF   SAL1108HVWR

  4   48  SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-45AF   SAL1101DA1H

  5   48  SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-45AF   SAL1108HVYY

  6   48  SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-45AF   SAL1109JDRT

  7    2  Supervisor Engine 720 (Active)         WS-SUP720-3B       SAL1052CQWG

  8    2  Supervisor Engine 720 (Hot)            WS-SUP720-3B       SAL1125S0H1

  9   48  SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-45AF   SAL1109JB5G

10   48  SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-45AF   SAL1049ACJM

11   48  SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-45AF   SAL1051B46T

12   48  SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-45AF   SAL1109JB78

13    4  CEF720 4 port 10-Gigabit Ethernet      WS-X6704-10GE      SAL10392T6G

[sean_evershed]

Hi,

It may be too difficult but you could swap Module 1 with Module 12.

From memory I think the modules at the top power on first.

It is my understanding that this is also possible to change the order by writing a custom EEM script.

[rashmi.patel]

Thanks for the reply Sean.

I don't mind trying either option but before I do I have a couple of queries:

1) Is there a document somewhere which confirms that Module 1 will be loaded first.

2) I have never written an EEM script so I would need a guide on how to do it and also what actually needs to be done to force module 12 to load first.