?yet again, pbr on c3550 EMI?

[steve.dutky]

I have some confusion:

I have seen posts and configs for c3550 EMI policy based routing.

Although the c3550 SW Configuration guide ( http://cco.cisco.com/en/US/customer/docs/switches/lan/catalyst3550/software/release/12.1_19_ea1/configuration/guide/swiprout.html#wp1260543 ) contains examples for PBR, it also cites laundry list

of unsupported route-map commands, including those used in these same examples.

( http://cco.cisco.com/en/US/customer/docs/switches/lan/catalyst3550/software/release/12.1_19_ea1/configuration/guide/swuncli.html#wp1014499 )

Does "set ip next-hop" not work or just not covered by warranty?

Thanks for any insight.

[bjornarsb]

Hi,

Have you looked at this link ?

http://www.cisco.com/en/US/tech/tk364/technologies_configuration_example09186a00802135d3.shtml

HTH

BR,

Bjornarsb

[steve.dutky]

No luck:

I have configured a c3550emi running 12.1(22)EA8a as per the example with sdm prefer extended-match.

I have configured a loopback at 40.40.40.2 on the default gateway at 10.10.10.2.

Initiating a telnet to 40.40.40.2 from 20.20.20.4 connects immediately, apparently ignoring the route-map pbr configured on vlan2.

Have I missed something obvious?

many thanks,

[steve.dutky]

My bad:

default routes on the remote gateways pointed back to pbrExample. Telnet session traversed -> 30.30.30.2 -> 30.30.30.1 -> 10.10.10.2.

Still confused as to why "show route-map" and "debug ip policy" show nothing.