Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
327
Views
0
Helpful
2
Replies

C60 BOOT UP IN MAIN MODE AFTER SOFTWARE UPGRADE

Chet Cronin
Level 4
Level 4

‎04-24-2015 12:31 AM - edited ‎03-18-2019 04:23 AM

Any one aware of why the C60 would go into maintenance mode after software upgrade from TC5.0.1 to TC7.2.1???

Software loaded and appears to install properly ???

Thanks.

 

Chet Cronin
Labels:
0 Helpful
2 Replies 2

Manish Gogna
Cisco Employee
Cisco Employee

‎04-24-2015 03:33 AM

Hi Chet,

You can try a factory reset in addition to the suggestions in the following post for similar issue

https://supportforums.cisco.com/discussion/12394476/c60-possibly-faulty

HTH

Manish

0 Helpful

Manish Gogna
Cisco Employee
Cisco Employee

‎04-24-2015 03:35 AM

Hi Chet,

You can try a factory reset in addition to the suggestions in the following post for similar issue

https://supportforums.cisco.com/discussion/12394476/c60-possibly-faulty

HTH

Manish

0 Helpful
Customers Also Viewed These Support Documents