The codec pro doesn't have any serial connectivity, so cannot control a Visca camera directly. You would need to add some third party equipment in between. (Ie, you could set up buttons for camera control on the Touch10 UI, then have an external device monitoring for these presses via the xfeedback or a macro, then trigger its own serial connection command to the connected Visca camera, or even a custom IP control command).
If you use one of the Cisco Cameras (ie Precision 60), then camera control is done by the codec over the Ethernet connection using the endpoint API.
Wayne
Please remember to mark helpful responses and to set your question as answered if appropriate.
