cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1065
Views
0
Helpful
1
Replies

Cisco Collaboration integration with Polycom

Sergey Svishenko
Enthusiast
Enthusiast

Hello!

 

At this moment in my company I have separated videoconference network on Polycom equipments/software (DMA 7000, RMX 4000) and

separated IP Telephony network on Cisco equipments/software (Cisco UCM 9.1.2).

I want to integrate this two separeted network and use for this purpose Cisco VCS Expressway Core Server.

From Cisco UCM I configure SIP trunk to VCS, on VCS create Zone to CUCM.

From DMA I configure two separate trunk - H.323 and SIP.

When I test calls I have following problems.

1) DMA (sip) <-> VCS <-> (sip)  CUCM: doesn't work presentation sharing (BFCP protocol), all other options work fine.

2) DMA (h.323) <-> VCS <-> (sip): doesn't work DTMF signal, when I call from Cisco IP Device to Polycom VMR conferencing.

 

I need help to resolve these problems.

 

1 Reply 1

heathrw
Enthusiast
Enthusiast

 

Hi,

 

Register a device to the VCS and try the content sharing there to see which SIP side is having the issue.

 

I would stick with SIP only end to end, check on the call manager side the VCS Trunk settings that the SIP Profile has BFCP enabled.

 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: