07-02-2012 01:49 AM - edited 03-17-2019 11:24 PM
Hi Guys,
Any idea where can I select the audio outputs from the codec (i.e mono, stereo) ? Currently I am only getting audio from the "Green" output. Both speakers were tested working when connected to the "Green" output. When connected to the "Red" and "White" (left, right) outputs, I am not getting any audio.
Thanks
Solved! Go to Solution.
07-03-2012 08:49 PM
Hello Wee Teck
Is this system setup in CUCM as 1000? That would explain you getting audio only on green port (center).
All CTS's by default are CTS 1000, then it changes once is added to CUCM (also you can do it from CLI).
CTS 1100 is same as CTS 1300. Left speaker -> white port, right speaker -> red port.
Regards
Rafal
07-03-2012 07:47 PM
Hi,
Anyone got any idea on this?
Thanks
07-03-2012 08:49 PM
Hello Wee Teck
Is this system setup in CUCM as 1000? That would explain you getting audio only on green port (center).
All CTS's by default are CTS 1000, then it changes once is added to CUCM (also you can do it from CLI).
CTS 1100 is same as CTS 1300. Left speaker -> white port, right speaker -> red port.
Regards
Rafal
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide