AllI have a 3511 MCU which isn't booting, I get:Invalid application on flash. Running Wakeup programI get a prompt, but I cannot find on documentation on the CLI syntax or if its possible to recover and restore the box.If anyone can help it would be greatly appreciated as this box is long past it's EoL and support.RegardsSent from Cisco Technical Support iPad App
What software version of MCU do you have? Did you try upgrade/downgrade it?
There is one thing you can try:
Can you run upgrade utility then use customize option and tick 3 options only (H323 configuration, wake up option, factory default). See if that help.
I can't run the upgrade utility because there's no IP connectivity.
On the console I get the following:
Invalid application on Flash. Running Wakeup program.
ttached TCP/IP interface to motfcc unit 0
Attaching interface lo0...done
Adding 5351 symbols for standalone.
CPU : MPC755
VxWorks Version : 5.5
BSP version : 1.70
Created : Jan 11 2004, 17:43:16
WDB : Ready.
BSP version VER_2_0_1REV 1.0
Memory Size: 128 MBytes.
bspSetRoutingTable: Error in routeAdd.
BSP_EXC: Exception hook added
Link is Up, 100M Full Duplex.
Duplex Mode: Manual Full Duplex.
Speed Mode: Manual 100M.
MEMORY OK (address: 0x0 - 0x3000)
Invalid application on Flash. Running the Wakeup program.
So the problem remains I have no documentation on the command line, and is it possible to recover this box.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: