12-13-2019 10:09 PM - edited 12-13-2019 10:11 PM
Network [1] IPv4 Assignment: Static
IP Address, GW & Subnet Mask Assigned
DX80 IPv4 Address is what it takes from Wi-Fi DHCP
I have tried this at a customer site multiple times even used a mobile hot spot, tried firmware downgrade, CLI Commands for IP & factory reset and it didn't work (means stills assigned DHCP IP & not the static one)
So what i want to confirm is did any one actually tried this before in lab or is there an official Cisco Guide that says the endpoint supports that ?
Tried Firmware Versions:
CE8.3.7
CE10.?? (don't actually remember the full path right now)
Note:
We solved the issue at the end by using Ethernet but i wanted to confirm the above
12-16-2019 02:21 AM
Hello,
It is not supported to configure wifi settings on DX80 device.
It will just show the available wifi networks and you can connect anyone via putting credentials(if there) apart from this you can not configure anything related to wifi.
Please see the below admin guide for your version-
(check -" NetworkServices WIFI Allowed page 84/ 85 )
Thanks
Please rate if it is helpful and mark as accepted solution if applicable....
12-16-2019 06:04 AM
12-16-2019 07:07 AM
Hi Anas,
Yes that is only for ethernet connection not for WiFi
As i mentioned you will not be able to configure anything regarding WiFi
You can raise a feature request for that through you Cisco account teams with proper business justification
May be they will include in feature releases if possible.
Thanks
Please rate if it is helpful and mark as accepted solution if applicable...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide