cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
713
Views
0
Helpful
1
Replies

Cisco EX60/90 and cyrillic keyboard/symbols

Hi

Problem - can't switch to cyrillic layout on Cisco EX:

ex1.jpg

Also, when H.323 identifier on MCU is cyrillic:

ex2.jpg

incorrect characters are displayed on terminal when an incoming call:

ex3.jpg

Is it possible to fix these problems in theory?

1 Reply 1

Rafal Szeremeta
Cisco Employee
Cisco Employee

Hello Alexander

What version of software you have? Can you check those settings please:

xConfiguration Video OSD InputMethod InputLanguage

The codec can be enabled for Cyrillic input characters in the GUI (Graphical User Interface). NOTE:

Requires that xConfiguration Video OSD inputMethod Cyrillic is set to On.

Valuespace:

Latin: Latin characters can be entered when using the remote control (default setting).

Cyrillic characters can be entered using the remote control. NOTE: Requires a TANDBERG Remote

Control TRC5 with Cyrillic fonts.

Example: xConfiguration Video OSD InputMethod InputLanguage: Latin

xConfiguration Video OSD InputMethod Cyrillic

This configuration is used to hide or show the Cyrillic mode as menu input language in the GUI (Graphical

User Interface).

Valuespace:

On: Cyrillic mode is available as a menu input language in the GUI. This will enable the setting

xConfiguration Video OSD InputMethod InputLanguage.

Off: Cyrillic mode is NOT available as a menu input language in the GUI.

Example: xConfiguration Video OSD InputMethod Cyrillic: Off

Cheers

Rafal

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: