11-11-2011 03:18 AM - edited 03-17-2019 10:36 PM
Hi,
I have the task of allowing calls route between an Avaya IP Office and a CCME running on a 3825 router. I have both devices on the same subnet, but I have been unsuccessful so far in getting calling routed between them.
I would appreciate any pointers in getting this done as I would rather start from scratch.
All comments and suggestions are very welcomed.
Regards,
Femi
12-02-2011 06:13 AM
Can you post the cme config
Sent from Cisco Technical Support iPhone App
12-02-2011 07:18 PM
Hi there,
I posted this same question in another forum and I have it resolved already. Kindly refer to the link below:
https://supportforums.cisco.com/message/3501347#3501347
Regards,
Femi
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide