11-30-2017 10:42 AM - edited 03-18-2019 01:39 PM
I'm setting up a couple of LG tv's with SX10's and the power on from CEC takes 17 seconds. With the remote, the TV comes up in 2 seconds. Any ideas?
Solved! Go to Solution.
11-30-2017 08:31 PM
I had a similar issue with an SX80 using CEC to LG TV's - never did fix it though :(
I ended up turning CEC off and just leaving the displays to go into "warm standby". This meant that the "no input source" message would show on the displays for around 10 minutes then the screens would go black, but as soon as the codec woke up the displays would come on again.
11-30-2017 08:31 PM
I had a similar issue with an SX80 using CEC to LG TV's - never did fix it though :(
I ended up turning CEC off and just leaving the displays to go into "warm standby". This meant that the "no input source" message would show on the displays for around 10 minutes then the screens would go black, but as soon as the codec woke up the displays would come on again.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide