12-12-2016 02:30 AM - edited 03-18-2019 06:41 AM
Hi there,
I would like to use the VESA Mount Adapter on my DX80 unit, but I have no screws to take off the existing stand as per
the instructions here:- http://www.cisco.com/c/dam/en/us/td/docs/voice_ip_comm/dx/dx80/install/dx80-vesa-mount-installation-sheet.pdf
I have attached 2 pictures:-
img_1479.jpg - Supplier DX80 (Showing screws)
file.jpg - This is my DX80 (Showing no screws)
Any help would be much appreciated.
Cheers,
Saul
04-06-2018 11:14 AM
Did you ever get an answer about the covered screws on the back of your DX80? I have the same issue but have been unable to find information about gaining access to the screws I am sure are beneath the cover. All the diagrams on the Cisco website show exposed screw heads. Thanks!
04-07-2018 06:01 PM - edited 04-07-2018 06:04 PM
HI @lori.armstrong,
You need to remove the white sticker, which is covering the screw-holes to expose them.
See belowimage:
Regards,
Rishabh Gupta
-Rate the response if found helpful.
04-07-2018 09:40 PM
04-07-2018 11:19 PM
04-09-2018 01:37 PM
08-17-2018 09:12 PM
Where did you find your Vesa Mount kit? I am in the market to purchase one as well as the wall mounted arm.
08-17-2018 09:44 PM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide